Walter Replacement Carbon Brush Set for Big Buff III and Line-Mate III

Get Your Finisher Back in the Fight

There is nothing worse than being in the middle of a mirror-finish job on a stainless steel railing and having your Line-Mate or Big Buff start sputtering. If your tool is losing power, smelling like burning ozone, or you see excessive sparks flying inside the housing, it’s time to check your brushes. The Walter 48M802 Carbon Brush Set is the exact replacement you need to bring your Big Buff III or Line-Mate III back to life. Don't risk burning out a several-hundred-dollar tool by ignoring a ten-dollar maintenance part.

These aren't generic, one-size-fits-all brushes that you have to file down to fit. These are genuine Walter parts, built to slide right into the brush holders of your Model 60-A 265 or 30-A 268. They come with the springs and leads attached, making the swap quick and painless so you can get back to work. Worn-out brushes are the number one killer of electric power tools; when they get too short, they stop making good contact, causing the motor to run hot and jerky. If you let them go too long, you'll fry the armature, and then you're shopping for a whole new machine.

We recommend keeping a set of 48M802 brushes in your shop drawer if you run Walter finishing tools daily. Swapping them out is a 10-minute job that saves you weeks of downtime and the cost of a new tool. Keep your RPMs steady and your finishes consistent by ensuring your motor is getting the clean power it needs. This set includes both brushes needed for one tool.