Walter ICECUT 100 Replacement Coolant Reservoir Assembly

Keep Your ICECUT 100 Running Cool

There is nothing worse than stopping a job because a simple plastic part broke. If the coolant bottle on your Walter ICECUT 100 magnetic drill has been cracked, lost, or clogged, the 48H310 Coolant Bottle Assembly is the exact replacement you need to get back to making holes. Magnetic drilling generates intense heat, and without a steady flow of coolant, you are just burning up expensive annular cutters and risking damage to your drill motor. This replacement bottle gets your lubrication system working again so you can focus on the fabrication work.

This isn't a generic bottle you have to duct tape into place. It is the official Walter part, meaning it fits right into the bracket on your ICECUT 100 and connects perfectly to the feed line. No leaks, no mess, and no hassle. The bottle is tough enough to handle the knocks and bangs of a busy job site, and it holds enough coolant to keep you drilling for a good stretch before needing a refill. The clear plastic lets you see exactly when you are running low, so you don't run dry in the middle of a deep hole.

Using the proper coolant delivery system is the secret to drilling faster and cleaner. When the coolant flows correctly from this bottle assembly, it washes chips out of the cut and keeps the cutting edges sharp. This means you put less strain on the magnet and the motor, and you get a cleaner hole with less burr. Don't try to manually squirt oil on the cutter while it spins—that's messy and dangerous. Fix your rig properly with this replacement assembly.

Whether you dropped the drill or the old bottle just wore out from years of UV exposure and chemical contact, swapping it out is quick. Don't let a twenty-dollar part hold up a million-dollar project. Grab a replacement Walter 48H310 Coolant Bottle Assembly and keep your mag drill operating at peak performance. It’s a small investment that saves you a fortune in burnt-up drill bits.