Canadian owned and operated
When your go-to finishing tool goes down, production stops. The Walter Drive Shaft (48T010) is the specific replacement part you need to fix a broken or bent spindle on your Line-Mate III. If you've noticed your finishing drum wobbling, making strange noises, or simply not spinning while the motor runs, the drive shaft is often the culprit. This isn't a generic knock-off; it is the authentic part from Walter Surface Technologies, meaning it fits perfectly right out of the box without any need for modification or guesswork.
Linear finishers take a beating in the shop. Whether you are graining stainless steel railings or polishing food-grade tanks, you lean on the tool to get the job done. That pressure eventually takes a toll on the internal mechanics. This replacement shaft is built tough to handle the torque and the heat of daily metalworking. Swapping out a damaged shaft is a smart, cost-effective way to extend the life of your expensive power tool rather than replacing the whole unit. It restores that smooth, balanced feel you had when the tool was new, helping you avoid those annoying vibration marks that ruin a perfect finish.
Don't let a small mechanical failure hold up your fabrication line. Keep a spare 48T010 Drive Shaft in your maintenance crib or order it immediately when signs of wear appear. Installation is standard for tool repair, allowing you to get back to buffing, sanding, and polishing in no time. Trust genuine Walter parts to keep your equipment running as hard as you do.
| Additional Information |
|---|
| Packaging Description:1 per each |
| Compatible Tool:Line-Mate III |
| Part Type:Drive Shaft |
| Material:Hardened Steel |
