Walter 15/16 Inch x 3 Inch Carbide Tipped Annular Cutter

Reliable Deep-Hole Drilling for Magnetic Drills

When your job site demands drilling through thick, hard metal, the Walter 15/16" x 3" Carbide Core Cut annular cutter is the tool you can trust. Built to withstand the rigors of heavy-duty construction and fabrication, this cutter is specifically designed for use with magnetic drilling units. Its 3-inch depth of cut capability makes it ideal for drilling through heavy structural beams, thick mounting plates, and multi-layered materials where standard cutters fall short.

The primary advantage of this Walter cutter is its ability to handle materials that are notoriously difficult to drill. If you frequently work with stainless steel or cast iron, you know that standard bits can dull quickly or burn up. The carbide tips on this model resist heat and abrasion, delivering a much longer service life and a lower cost per hole over time. This durability means fewer tool changes in the middle of a job, keeping your project on schedule.

In addition to its toughness, the 05D615 is designed for speed. It cuts only the periphery of the hole, ejecting the center as a solid slug. This requires less power and energy than twist drills, which must turn the entire volume of the hole into chips. The result is a cleaner, burr-free hole produced in a fraction of the time. Upgrade your magnetic drill kit with Walter Carbide Core Cutters for superior performance on every hole.