12D808 - Walter W-222 Stainless Steel Mounted Grinding Point

Get Into Tight Corners with Confidence

When you are finishing a stainless steel job, the last thing you want is a cheap grinding stone that bounces around, chatters, or leaves rust-causing contaminants on your perfect weld. The Walter W-222 Mounted Point is built for professional welders who need to get into tight spots—like the inside of a pipe, a corner joint, or a machined hole—and clean it up fast. This isn't just a generic stone; it is formulated specifically for Inox (stainless steel), meaning it cuts free and cool without glazing up.

The "W-222" shape is a classic 1-inch by 2-inch cylinder. It’s the workhorse of die grinder attachments. You can use the face for bottoming out in a hole or the sides for smoothing out internal diameters and edges. Because it is made by Walter, you can feel the difference in the balance immediately. There is no wobble or vibration that numbs your hands after five minutes of grinding. It runs true, allowing you to control the cut precisely, which is critical when you are doing finish work on expensive stainless parts.

Pop this 1/4-inch shank into your die grinder and tackle tasks like enlarging bolt holes that are just a hair too small, blending out root passes, or removing burrs from cut edges. It holds its shape longer than standard stones, saving you time on dressing and changing out bits. If you work with stainless, this is the mounted point you want in your toolbox.