Walter ZIP 4-Inch Type 27 Cut-Off Wheel for Die Grinders

The Ultimate Die Grinder Cutting Wheel

When you are in a tight spot and need to make a precise cut, the Walter 11L408 ZIP™ Wheel is the tool you want on your die grinder. Most welders are familiar with the legendary performance of Walter ZIP wheels on angle grinders, and this 4-inch version brings that same cutting power to your straight shaft tools. With a 3/8-inch arbor hole, it fits perfectly on standard pneumatic or electric die grinders, giving you the ability to slice through metal in places where a bulky angle grinder just won't fit.

This isn't your average cutoff wheel. It features a Type 27 depressed center, which is a game-changer for visibility and access. The raised hub allows you to get the wheel flush against a workpiece or into awkward corners without the mounting nut getting in the way. At only 1/32 of an inch thick, this wheel is razor-thin. This means it slices through steel and stainless steel like butter, creating a very narrow kerf and generating almost no heat. For you, that means less discoloration on your stainless welds and less time spent cleaning up heat tint.

We know that changing out wheels is a hassle that kills your rhythm. Walter has engineered these wheels to last longer than the competition, thanks to a special rib design and high-quality abrasive grains that stay sharp until the wheel is done. Whether you are notching out a pipe for a saddle fit, trimming a bracket, or cutting off a rusted bolt in a deep recess, this wheel holds up. It is tough, reinforced for safety, and won't bog down your tool.

Stop struggling with cheap wheels that shatter or wear down in seconds. The 11L408 is built for serious fabrication. It is guaranteed not to contaminate your stainless steel, so you don't have to worry about rust popping up later. Upgrade your die grinder setup with the wheel that cuts faster, runs cooler, and lasts longer.