CS6290NXP2 - Victor CutSkill 6290NXP-2 Propane Cutting Tip Size 2

High-Performance Propane Cutting with the CS6290NXP2

Maximize the efficiency of your oxy-fuel cutting operations with the Victor CutSkill CS6290NXP2, a direct replacement for the widely used Harris 6290NXP-2 cutting tip. This tip is specifically engineered for use with Propane and Natural Gas, making it an essential consumable for industrial environments where these cost-effective fuels are preferred over acetylene. The "NXP" designation indicates a two-piece tip designed for general hand cutting, offering a balance of preheat intensity and cutting speed suitable for a wide variety of steel grades.

Technical Specifications and Performance
The Size 2 orifice is precision-drilled to handle material thicknesses between 1 inch and 2 inches. At optimal pressure settings, this tip produces a coherent oxygen stream that clears molten slag efficiently, leaving a kerf with minimal dross. The two-piece design is critical for alternative fuels; the recessed inner tip anchors the flame, preventing it from blowing off the tip face even at high flow rates. The outer copper sleeve withstands reflected heat and accidental contact with the workpiece, significantly extending the lifespan of the consumable compared to single-piece designs used for acetylene.

Compatibility and Application
This tip is fully compatible with any cutting torch or attachment designed to accept Harris 6290 style tips. It is an ideal choice for structural steel fabrication, heavy equipment repair, and scrap processing. The general-purpose preheat flame is versatile enough to handle mill scale and light rust, ensuring rapid starts and continuous cuts. By utilizing the Victor CutSkill CS6290NXP2, welders and fabricators can maintain high productivity levels while benefiting from the lower operating costs associated with propane and natural gas.

Maintenance and Safety
To ensure optimal performance, always inspect the seating surfaces of the tip before installation. The CS6290NXP2 features machined seats that prevent dangerous gas mixing within the torch head. Regular cleaning with appropriate tip cleaners will maintain the integrity of the preheat holes and cutting oxygen bore, ensuring the flame remains neutral and the cutting stream remains straight. Always verify that your regulator pressures match the manufacturer's recommendations for a Size 2 propane tip to prevent overheating or flame instability.