0717-0003 - Victor 0717-0003 Inlet Filter for VTS 400 and SR 250 Regulators

Keep Your Victor Regulator Flowing Smoothly

Don't let a five-dollar part ruin a three-hundred-dollar regulator. The Victor 0717-0003 Filter is the exact replacement part you need to keep your VTS 400 or SR 250 series regulator working like new. Every time you crack a cylinder valve, there is a risk of dirt, rust, or cylinder scale shooting into your regulator. If that grit hits the soft seating material inside your regulator, it creates a leak path. This leads to creeping pressure, erratic flames, and eventually, a regulator that is unsafe to use.

This sintered filter acts as a microscopic screen, catching that debris before it can do any damage. It is designed to handle the high pressures associated with oxygen and fuel gas cylinders while delivering the steady flow rate you expect from a Victor regulator. If you have noticed that your regulator is struggling to keep up with demand, or if you are performing a yearly tune-up, checking and replacing this filter is step one. A clogged filter can starve your torch of gas, leading to popping, backfires, or poor cut quality.

Why choose the Victor 0717-0003?

• Perfect Fit: Designed specifically for the inlet nipples of VTS 400 and SR 250 models. No guessing if it will seat correctly.
• Superior Filtration: The sintered metal design traps finer particles than simple wire mesh screens found in cheaper alternatives.
• Safety First: A clean filter reduces the risk of high-pressure oxygen impingement on contaminants, which is a critical safety factor in oxy-fuel welding and cutting.

Maintenance is simple. When you have your regulator off the tank, take a look at the inlet. If the filter looks dark, crushed, or clogged, swap it out. It’s one of the easiest and cheapest ways to extend the life of your welding gear. Trust genuine Victor parts to keep your shop running safely and efficiently.