0416749887 - ESAB 2-Meter Replacement Interconnection Cable

Get Your Rig Back Online with Genuine ESAB Parts

There is nothing more frustrating than a welding machine that acts up because of a bad connection. Whether it's a control signal dropping out or a peripheral device losing power, a damaged cable can bring your work to a grinding halt. The ESAB 0416749887 Cable (2M) is the genuine replacement you need to swap out that cut, crushed, or worn-out cord and get back to laying beads. Designed specifically for ESAB equipment, this cable plugs right in without the headache of splicing wires or guessing pinouts.

Built for the Shop Environment
Welding shops are tough places. Cables get stepped on, dragged over sharp metal edges, and exposed to sparks. While no cable is indestructible, ESAB's OEM replacements are built with the durability you expect from a top-tier welding brand. The insulation is tough enough to handle daily abuse, and the connectors are molded to resist strain, ensuring that the connection stays tight even when you are moving equipment around the bay. At 2 meters long (about 6.5 feet), it gives you the reach you need for standard setups without leaving coils of wire on the floor to trip over.

Why Stick with OEM?
Modern welders are smart machines. They rely on clean data signals to control arc characteristics, wire feed speed, and voltage. A cheap aftermarket cable might look the same, but if the shielding isn't up to par, you could end up with ghost errors or erratic arc performance. Using the official ESAB 0416749887 cable guarantees that your machine performs exactly how the engineers intended. It’s a small investment to protect the performance of your high-value welding power source.

Quick Fix, Long-Term Reliability
Don't wait until the cable fails completely. If you see exposed copper, cracked insulation, or taped-up sections on your current cable, it's time to replace it. This assembly comes ready to install out of the box. Just disconnect the old one, route the new one, plug it in, and you are ready to weld. Keep your focus on the puddle, not on wiggling a wire to get the machine to start.