16301197 - Tweco 63-60 Flexible Gooseneck for Spray Master MIG Guns

Reach the Unreachable with the Tweco 63-60 Flex Neck

Every welder knows the frustration of a joint that is just out of reach. You try to contort your body, twist your wrist, or settle for a bad travel angle, all of which lead to poor bead profile or potential defects. The Tweco 1630-1197 Flexible Conductor Tube (Model 63-60) is the solution for your Spray Master MIG gun. Designed to replace your standard rigid gooseneck, this flexible tube puts you back in control of the puddle, no matter where the weld is located.

The "Flex" in the name isn't just a gimmick; it allows you to bend the neck to customize your approach. Whether you are welding inside a box section, around a pipe cluster, or reaching over a flange, you can adjust the neck to get the perfect gun angle. This ensures you maintain proper gas coverage and stick-out, which is critical for preventing porosity and lack of fusion. The tube comes pre-bent at a comfortable 60 degrees but gives you that extra versatility when the job demands it.

Despite its flexibility, this tube is built Tweco-tough. It handles the heat of 350A and 450A applications without overheating, thanks to high-quality internal copper braiding and conductors. It fits seamlessly onto your existing Spray Master MS350 or MS450 gun, so you don't need to buy a whole new torch rig. Plus, it uses your existing Spray Master consumables—tips, nozzles, and diffusers—so you can swap it in and get right back to burning wire.

Comfort is another huge factor. By adjusting the neck rather than your body, you reduce strain on your wrist and shoulder during long shifts. If you are tired of fighting your equipment to get into tight spots, upgrading to the Tweco 1630-1197 flexible conductor tube is one of the smartest investments you can make for your daily welding comfort and quality.