21541 - ESAB PT-24 Replacement Nozzle B - 30 Amp

Get Your PT-24 Cutting Like New

If you are running an ESAB PT-24 plasma torch, you know that the nozzle is the business end of the operation. The ESAB 21541 Nozzle B is the direct replacement part you need when you are cutting at 30 Amps. Over time, every plasma nozzle wears out. The intense heat and the high-velocity gas eventually widen the tip's hole or make it oval-shaped. When that happens, your arc starts to wander, your cuts get sloppy, and you end up with a lot more dross to grind off later. Swapping out a worn nozzle for a fresh 21541 is the quickest way to get back to clean, sharp cuts and save yourself time on cleanup.

This nozzle is built tough to handle the demands of the shop. It is made from high-quality copper that stands up to heat, but it is also a precision part. Because it is rated specifically for 30 Amps, it gives you the perfect balance of power and control for that setting. Don't try to squeeze by with a nozzle designed for a different amperage or a generic knock-off that might not fit right. Using the correct "Nozzle B" ensures that your gas flow is exactly where it needs to be, protecting your torch and your workpiece. It installs in seconds, seating perfectly into the PT-24 head so you can get back to work immediately.

We recommend keeping a few of these in your toolbox. Plasma cutting is hard on consumables, and you never want to be stuck in the middle of a job with a blown tip. Signs that you need to replace your nozzle include a green discoloration in the arc (which means you are burning copper), excessive slag, or a cut that is beveled instead of straight. By keeping fresh ESAB 21541 nozzles on hand, you ensure that your PT-24 is always ready to deliver professional results. Whether you are cutting sheet metal for HVAC, doing auto body work, or general fabrication, this 30 Amp nozzle is the reliable choice for your ESAB torch.