114Z08 - ESAB FG-2 MIG Gun Nozzle Extension Adapter

Keep Your FG-2 Gun Running Smoothly

Every welder knows that the front-end parts of a MIG gun take the most abuse. Spatter, heat, and constant threading and unthreading can wear down even the toughest components. The ESAB 114Z08 Nozzle Extension is the exact replacement part you need if you are running an ESAB FG-2 series gun. When your nozzle starts to wobble, or you can't get it to seat quite right because the threads on your current extension are stripped or battered, it’s time to swap it out. Using a fresh extension ensures your nozzle stays firm and centered, giving you the control you need over your puddle.

This extension isn't just about holding the nozzle on; it's about reach and gas coverage. In many setups, the extension dictates where your nozzle sits in relation to the tip, which affects your stick-out and gas shielding. If you are welding in tight corners or need to reach into a deep groove, having the correct extension geometry is key to avoiding porosity and getting a clean bead. Because this is a genuine ESAB part, you don't have to worry about it fighting you during installation. It threads on smooth and locks down tight, letting you get back to burning wire without fussing with your equipment.

Don't let a small part cause big headaches on the shop floor. If you rely on the FG-2 for your daily production or repair work, keeping a few of these 114Z08 extensions in your toolbox is a smart move. It ensures that when wear and tear finally takes its toll, you aren't left searching for a hard-to-find part for your specific gun model. Grab this clearance item while it's available and keep your ESAB torch performing like the day you bought it. It’s a simple fix that pays off in consistent weld quality and less downtime.