996527 - ESAB Replacement O-Ring 1.301 ID x .070 CS (Pack of 10)

Keep Your Gear Leak-Free

There is nothing more frustrating than hearing the hiss of a gas leak or realizing your shielding gas coverage is compromised because of a dried-out fifty-cent piece of rubber. The ESAB 996527 O-Ring pack is your insurance policy against those annoying leaks that waste gas and ruin welds. This pack comes with 10 high-quality O-rings sized exactly at 1.301 inches ID by 0.070 inches thick. If your ESAB equipment calls for this part number, don't try to jam a generic hardware store O-ring in there—get the right fit to ensure a tight seal every time.

O-rings are the unsung heroes of the welding world. They sit quietly in your torch connections, back caps, or machine liners, holding back high-pressure gas or coolant. Over time, heat and pressure flatten them out, or they get nicked when you change out parts. Once that happens, you start losing gas, or worse, sucking in air that causes porosity in your bead. Having a 10-pack in your toolbox means you can swap out a bad seal the moment you notice it, rather than wrapping it in electrical tape and hoping for the best until a new part arrives.

These O-rings are built to handle the shop environment. They resist drying out and cracking better than cheap alternatives. Because they come in a bag of ten, you can afford to replace them proactively during your regular equipment cleaning. Don't wait for a failure to happen in the middle of a critical job. If you are tearing down a torch or servicing a feeder, pop a new O-ring in to keep everything factory-fresh.

Perfect for the welder who takes care of their own rig, this pack is a small investment that saves money on wasted argon and rework. Check your manual or parts diagram to confirm the part number 996527, and keep this bag handy. It’s one of those small parts that stops the whole show if it's missing, so stock up and keep welding without interruptions.