GAP0.25 - 1/4 Inch Socket Weld Contraction Rings 20-Pack

The Fastest Way to Fit 1/4" Socket Welds

Let's face it: fitting small-bore socket welds can be a tedious pain. The standard procedure—jamming the pipe in, marking it, pulling it back an eighth or sixteenth of an inch, and hoping it doesn't slip while you tack it—eats up valuable time. And if you forget to pull it back? You risk cracking the weld or failing an X-ray inspection later. The Gap-O-Let 1/4" Socket Weld Rings are the cheat code for perfect fit-ups every single time. This pack of 20 rings is designed to make your life easier and your welds better.

Here is how it works: you take one of these spring-steel rings, squeeze it slightly, and pop it into the 1/4" socket fitting. It snaps into place at the bottom of the cup. Then, you just slide your pipe in until it hits the ring. That's it. You are done. The ring automatically creates the perfect 1/16" gap required by code. You can tack it up immediately without measuring, scribing, or guessing. The ring stays inside the joint forever, becoming a permanent part of the assembly, and because it is made of stainless steel, it won't contaminate your weld pool.

These rings are especially useful when you are working in tight spots, up on a rack, or in position where handling a tape measure and a marker is difficult. They hold themselves in the fitting, so you don't have to worry about them falling out while you position the pipe. Whether you are running stainless instrumentation lines or standard carbon steel piping, these Gap-O-Let rings ensure you aren't stressing the joint before you even lay a bead. Stop wasting time with the "mark and pull" method and start getting perfect gaps instantly.