TRIPLEHOSE25 - 25ft Grade T Triple Hose Assembly 3/8 Inch

Heavy-Duty 3-Line Hose for Serious Cutting

When you're running a cutting machine or a specialized torch setup, a standard twin hose just doesn't cut it. You need the 25' x 3/8" Grade T Triple Hose. This beast is built for the pros who need to run three separate lines—usually for your fuel, preheat oxygen, and that massive blast of cutting oxygen. By keeping these lines bonded together in a neat, flat ribbon, you avoid the spaghetti mess of cables on your shop floor, keeping your workspace safe and your setup looking professional.

Grade T: One Hose, Any Fuel

Don't worry about which gas you're running today. This hose is Grade T, which means it's built with a special liner that can handle everything. Acetylene? No problem. Switching to Propane or Natural Gas for cheaper cutting? You're good to go. Unlike cheaper hoses that rot out when you run propane through them, this hose is designed to resist the chemical attack of alternate fuels, keeping you safe and saving you money on replacements.

Maximum Flow for Thick Cuts

Size matters when you're cutting thick steel. This hose features a large 3/8-inch diameter, which is significantly bigger than the standard 1/4-inch hoses found on light-duty rigs. This extra width means you get maximum gas flow to your torch tip, ensuring you don't starve your flame when you hit the cutting oxygen lever. The result? Cleaner cuts, faster travel speeds, and less slag to grind off later.

Built Tough

The 25-foot length gives you plenty of room to move around your workpiece or track cutter without being tethered too closely to your cylinders. The tough outer jacket fights off oil, grease, and hot sparks, making it perfect for the daily grind of a busy welding shop. If you need a reliable, high-flow solution for your 3-hose torch, this is the upgrade you've been looking for.