KP3364-5 - AutoDrive SA Steel Jumpliner .035-.045

Keep Your Robot Running Smoothly

Every welder knows that the number one cause of frustration in MIG welding is a bad liner. When you are dealing with robotic welding, that frustration translates directly into lost production and downtime. The Lincoln Electric KP3364-5 AutoDrive SA Gooseneck Jumpliner is your solution for keeping the wire moving freely through the most difficult part of the gun—the neck. This specific liner is built to fit Lincoln's AutoDrive® SA goosenecks, acting as a bridge that guides the wire through the bend where friction is highest and jams are most likely to occur.

Built for the Daily Grind

This jumpliner is tough. It is made for running .035" to .045" steel wire, the bread and butter of many manufacturing shops. Because the neck of the gun takes the most heat and abuse, the liner inside it wears out faster than the rest of the cable. Instead of pulling out and replacing the entire conduit from the feeder to the tip, you can simply swap out this short jumpliner. It saves you money, but more importantly, it saves you the headache of re-threading a 10-foot liner when only the last 6 inches are worn out. The steel construction ensures it holds up against the drag of the wire, preventing the chatter that leads to sloppy welds.

Quick Fix, Better Welds

Installing the KP3364-5 is straightforward, getting your robot back to welding in minutes. A fresh jumpliner means less drag on the wire, which means your arc stays stable and your bead profile stays consistent. If you are noticing burn-backs or erratic feeding in your AutoDrive SA setup, checking and replacing the jumpliner is often the quickest fix. Don't let a worn-out coil ruin a batch of parts; keep a few of these KP3364-5 liners on the shelf to ensure your automation equipment performs as well as the day it was installed.