M1587 - Miller 15ft Control Cable Replacement - No Sleeve

Get Your Welder Back Online with the Miller M1587 Control Cable

There is nothing more frustrating than a welder that won't arc because of a bad connection. If your rig is down due to a faulty control cable, the Miller M1587 is the exact replacement you need to get back to burning wire. This 15-foot control cable is a genuine Miller part, meaning it’s built to the same tough standards as your machine. It’s designed to carry the essential signals that tell your wire feeder when to spin and your power source when to heat up. Don't risk your weld quality or waste time troubleshooting with generic, ill-fitting cables; stick with the brand that built your machine.

The M1587 comes as a 15-foot length, giving you plenty of reach to route the cable exactly where it needs to go. Note that this version comes without an insulating sleeve. This is actually a huge plus for many repairs, as it allows you to slide the cable easily through tight spots, existing conduits, or cable management tracks without fighting a thick, rubbery outer jacket. If your setup requires extra protection, you can easily add your own loom or tape, but for many internal repairs or protected runs, this streamlined design is exactly what the doctor ordered.

Swapping out a damaged control cable is often the quickest fix for intermittent issues like a stuttering wire feed or a trigger that only works when you wiggle the cord. By replacing the old, worn-out line with a fresh M1587, you eliminate the guesswork and ensure your machine responds instantly every time you pull the trigger. Keep your downtime to a minimum and your arc stable with this reliable, OEM replacement cable from Miller. It’s a simple part that plays a huge role in your daily productivity.