087131 - Miller .023 V-Groove Drive Roll Kit for Millermatic 200/250/252

Stop Fighting Your Wire Feeder

There is nothing more frustrating than a wire feeder that slips, stutters, or bird-nests right in the middle of a job. If you are running .023" solid wire for auto body work or light fabrication, your drive rolls are the heart of your operation. The Miller 087131 Drive Roll Kit is the direct replacement you need to get your machine running smoothly again. Worn-out grooves can't grip fine wire effectively, leading to burn-backs and uneven welds. This kit swaps out your old hardware with fresh, sharp V-grooves designed specifically to bite into solid steel and stainless wire without crushing it.

What's in the Box?

This isn't just a single wheel; it's a full refresh for your feeder's front end. The kit comes with two V-groove drive rolls and a new inlet guide. The inlet guide is critical—it aligns the wire perfectly as it comes off the spool, preventing it from scraping against the housing before it even hits the rolls. Installing this kit takes just minutes but can save you hours of troubleshooting and downtime.

Fits Your Trusted Machines

Whether you are running a classic Millermatic 200 in the shop or dragging a Suitcase feeder around a job site, this kit fits a huge lineup of Miller equipment. It works with the Millermatic 210, 212, 250, 251, and the industry-standard 252. It also fits the 22A and 24A feeders. If you are switching down to .023" wire for thin sheet metal, don't try to make your .030" or .035" rolls work—they won't track right. Grab the correct 087131 kit and get the buttery-smooth feed your welds deserve.