0218510281 - ESAB 1.6mm (1/16") Wire Drive Roll Replacement

Keep Your Wire Moving with the ESAB 1.6mm Feed Roll

There is nothing more frustrating in the middle of a heavy weld than feeling your wire stutter. You check your liner, you check your tip, but often the culprit is right inside the feeder: a worn-out drive roll. If you are running 1.6mm (1/16 inch) wire, you are likely laying down serious metal, and you need a feed system that can keep up. The ESAB 0218510281 Feed Roll is the genuine replacement part you need to restore that smooth, consistent hum to your wire feeder. When your rollers lose their grip, your arc starts to wander, and your spatter levels go up. Don't fight your machine; give it the traction it needs.

This feed roll is built tough. ESAB knows that running 1/16" wire puts a lot of stress on the drive system, so they manufacture these rolls from hardened steel that resists grooving and wear. Whether you are pushing solid wire for heavy structural steel or running flux-cored wire for deep penetration, this roller provides the bite required to push the wire through the torch cable without slipping. A slipping roll doesn't just annoy you; it can cause burn-backs that ruin your contact tips and downtime that kills your productivity.

Swapping out your feed rolls is one of the easiest and cheapest ways to tune up your welder. If you notice metal shavings accumulating under your drive rolls or if you have to crank the tension knob way down just to get the wire to feed, it’s time for a replacement. This specific roll is sized perfectly for 1.6mm wire, ensuring the wire sits correctly in the groove without being crushed. Keep a spare in your toolbox or maintenance locker so you aren't caught off guard when a roller finally gives up the ghost. Stick with genuine ESAB parts to guarantee the fit and performance your machine was built to deliver.