194117 - Miller XR-Edge .062 Wire Drive Roll Replacement Kit

Smooth Feeding for Your XR-Edge Gun

If you are running .062" (1/16") aluminum wire through your Miller XR-Edge gun, you know that feed consistency is everything. The Miller 194117 Drive Roll Kit is the genuine replacement part you need to keep that wire moving smoothly. Over time, the drive rolls in your push-pull gun can wear down, losing their grip on the wire. When that happens, you start seeing slipping, stuttering, and frustrating burn-backs that ruin your contact tips and your patience. This kit brings your gun back to factory-fresh performance.

Designed specifically for the mechanics of the XR-Edge, this drive roll features a groove that perfectly cradles 1/16" wire. Because it is a push-pull system, this little roll does a lot of the heavy lifting at the front end, pulling the wire through the final stretch of the cable. The design ensures it grabs the wire tight enough to feed it but gentle enough not to crush soft aluminum or shave off metal flakes that could clog your liner. It’s the kind of reliability you expect from Miller Electric.

Installation is straightforward, allowing you to get back to welding in minutes. Whether you are fabricating boat hulls, trailers, or heavy industrial aluminum structures, having a fresh drive roll ensures your arc starts are crisp and your bead appearance is uniform. Don't let a worn-out $30 part cost you hundreds in downtime and rework. Keep a spare 194117 kit in your toolbox so you are always ready to tackle heavy-gauge aluminum jobs with confidence.

This kit includes the drive roll and necessary hardware for the swap. Remember, this is for the gun itself, not the feeder box. Match it up with your .062" wire setup, check your tension settings, and you will be laying down dimes with the smooth, hum-free feeding that the XR-Edge is famous for.