258295 - Miller 10-Inch 45-Degree Head Tube for XR-Aluma-Pro and Spoolmatic Pro

Reach the Unreachable with Miller's 10-Inch Head Tube

Every welder knows the frustration of a joint that is just out of reach. Whether it's inside a deep channel, around a tight corner on a boat hull, or within a complex trailer frame, standard MIG gun necks often just don't cut it. The Miller 258295 Head Tube Assembly is the solution for those hard-to-reach welds. Specifically designed for your Miller Spoolmatic Pro or XR-Aluma-Pro push-pull gun, this 10-inch long neck gives you the extra extension you need to weld comfortably without compromising your visibility or gas coverage.

The 45-degree angle is the perfect balance for most tight-access applications, allowing you to keep your hand and the gun body clear of the workpiece while directing the arc exactly where it needs to go. One of the best features of this head tube is how easy it is to use. You don't need to hunt for an Allen wrench or a pair of pliers to swap it out. The Quick-Change design lets you pull off your standard head and snap this one on in seconds. It seats itself perfectly every time, so you don't have to worry about gas leaks or a loose connection ruining your weld.

Comfort is also a major factor when welding all day. Because this tube is fully rotatable 360 degrees, you can adjust the angle of the neck relative to the handle. This means you can weld overhead, vertical-up, or in awkward positions without twisting your wrist into a pretzel. It’s a genuine Miller part, meaning it’s built tough to handle the heat and abuse of daily fabrication work. If you are welding aluminum with a Pro series gun, keeping this extended head tube in your kit ensures you are never stopped by a difficult angle again.

Why Welders Choose This Head Tube:

• Access: Get into tight corners and deep spots with the 10-inch reach.
• Speed: Swap heads in seconds with no tools required.
• Comfort: Rotate the neck to fit your welding position, saving your wrists.