Western Enterprises 808 Brass Ferrule for 1/4 Inch ID Hose

Reliable Hose Repair for the Professional Welder

When you are in the middle of a fabrication job, a damaged welding hose can bring everything to a halt. The Western Enterprises 808 Brass Ferrule is your go-to solution for fixing leaks or building custom hose assemblies right in the shop. Designed specifically for standard 1/4-inch I.D. welding hoses (the kind with a 1/2-inch outer diameter), this ferrule allows you to create a secure, professional-grade connection that holds up to the rigors of daily use.

Why replace an entire 50-foot hose just because of a cracked end or a bad fitting? With a handful of these 808 ferrules and a crimping tool, you can cut off the bad section, insert a new barb, and crimp on a fresh ferrule in minutes. The brass construction is tough enough to protect the hose end but soft enough to crimp down tight, ensuring you don't have any gas leaks at the torch or regulator. This is the same hardware used by hose manufacturers, so you know you are getting a factory-quality repair.

These ferrules aren't just for repairs; they are essential for customization. Maybe you need a short "whip" hose for better torch maneuverability, or perhaps you need to run a line to a machine located far from your tanks. The Western Enterprises 808 gives you the freedom to build exactly what you need. The 1-inch length provides plenty of grip on the hose barb, preventing the fitting from popping out even when you drag the hose around the shop floor.

Safety is the number one priority when dealing with oxy-acetylene or shielding gases. Hose clamps can snag on equipment and often don't provide a uniform seal on small-diameter hoses. A proper crimped ferrule like the 808 is the safest, most streamlined way to secure your fittings. Keep a stock of these in your toolbox or parts bin so you are never stuck waiting for a replacement hose when you should be burning metal.