238M - 2-3/8" Bi-Metal Hole Saw, Heavy Duty Pipe & Metal Cutter

Cut 2" Pipe Holes Fast with the Techniweld 2-3/8" Hole Saw

If you are fitting pipe or running lines, you know that a 2-3/8" hole saw is one of the most important tools in your kit. It’s the exact size you need for a 2-inch pipe OD, making it perfect for creating tight pass-throughs in bulkheads, plates, or studs. Techniweld brings you a "Pipe Cutting Edge" that doesn't mess around. This isn't a cheap hardware store bit; it's a bi-metal beast designed to chew through mild steel, stainless, and whatever else is in your way without losing its teeth after the first cut.

We know that on the job site, time is money. You can't afford a saw that binds up or dulls halfway through a firewall. This cutter uses high-speed steel teeth that stay sharp longer, even when you're pushing it hard. The variable tooth design helps clear chips out of the kerf, keeping the bit cooler and stopping it from grabbing and twisting your wrist. It cuts smooth, fast, and clean, leaving you with a hole that needs minimal deburring so you can get on with the weld or the install.

Durability is key. The bi-metal construction means the teeth are hard, but the backing is tough and flexible, so it won't shatter if you hit a snag. It’s got deep slots on the side so when you're done, you can pop that hot slug out with a screwdriver and get right to the next hole. Pair this with your standard 5/8-18 arbor and a good pilot bit, and you're ready to tackle any fabrication, plumbing, or electrical job that comes your way. Don't settle for less when you need to cut metal.