Canadian owned and operated
There is nothing worse than a small part shutting down your whole operation. If you've misplaced the retaining nut for your Hypertherm Powermax air filter during a routine change-out, or if the old one has stripped threads, the Hypertherm 428262 is exactly what you need to get back to cutting. This is the genuine nut that screws onto the bottom of the filter assembly to hold the filter element tight.
Why is this little nut so important? If your air filter isn't seated perfectly, dirty air and moisture can sneak past it and get into your torch. Moisture is the enemy of plasma cutting—it eats up your electrodes and nozzles faster than you can replace them. By securing your filter with this OEM retaining nut, you ensure that your air supply stays dry and clean, protecting your expensive torch and consumables.
Installation is a breeze; it's designed to fit your machine perfectly without any fighting or cross-threading. Don't risk using a makeshift fastener from the hardware store that might not hold up to the pressure or fit quite right. Stick with the genuine Hypertherm 428262 to keep your machine warranty intact and your cuts looking sharp. It's a smart, low-cost part to keep in your toolbox just in case.
| Additional Information |
|---|
| Brand:Hypertherm |
| Item:Accessory |
| Packaging Description:1 per each |
