0559211620 - ESAB PT-36 200A Bevel Nozzle

Maximize Your Bevel Cuts with the PT-36 200A Tip

When you are running a high-amperage plasma table, the quality of your consumables directly dictates the quality of your cut. The ESAB 0559211620 is the 200A Bevel Tip designed for the PT-36 torch, and it is built to handle the heat. If you are cutting bevels for weld prep, you know that a blown-out tip or a wandering arc can ruin a massive piece of plate in seconds. This genuine ESAB nozzle is engineered to keep that arc tight, focused, and exactly where you need it, even at a steep angle.

Bevel cutting puts a lot of stress on the front end of the torch. The arc is stretched, and the blowback can be intense. This 200A tip features a reinforced orifice geometry that resists erosion better than standard tips. This means you get more arc-on time and fewer interruptions to swap out parts. The clean, consistent arc produced by this nozzle helps reduce dross buildup on the bottom edge of the cut, saving you time on grinding and cleanup later. It’s all about efficiency—drop the tip in, set your parameters, and trust it to perform.

Installation is straightforward, fitting perfectly into the PT-36 consumable stack. Because it is an OEM part, you don't have to worry about thread mismatches or coolant leaks that can happen with knock-off brands. The fit and finish ensure that the cooling water circulates properly around the nozzle, pulling heat away from the orifice and preventing premature failure. This is crucial when you are pushing 200 amps continuously.

Whether you are working with mild steel, stainless, or aluminum, having the right tip for the job is essential. This specific nozzle is tailored for the beveling process, ensuring that the gas shielding and plasma stream are aligned for angular penetration. Don't compromise your cut quality with worn-out or incorrect parts; keep your PT-36 running at peak performance with fresh, genuine ESAB 200A bevel tips.