770724 - Hobart 770724 Electrodes for AirForce 700i - 5 Pack

Keep Your AirForce 700i Cutting Cleanly

There is nothing more frustrating than a plasma cutter that sputters, loses its arc, or produces jagged, ugly cuts right in the middle of a job. Often, the culprit is a worn-out electrode. The Hobart 770724 Electrode 5-Pack is your insurance policy against downtime. Designed specifically for the Hobart AirForce 700i, these electrodes are the heart of your torch, responsible for carrying the current that creates the plasma arc. When your electrode is fresh, your machine starts instantly and cuts through steel like butter.

Why buy a 5-pack? Because plasma electrodes are consumables that wear out with every start and stop. Having a single spare is risky; having a pack of five means you can finish that big project without running to the store. These are genuine Hobart parts, not cheap knock-offs that might rattle in the torch or burn out in five minutes. They fit perfectly, thread in smoothly, and make good electrical contact every time. This ensures your machine runs as the engineers intended, protecting your expensive torch handle from overheating or shorting out.

Knowing when to change your electrode is key to getting the best value. If you notice the cut quality dropping, the arc turning green (which means you are burning copper!), or difficulty starting the arc, it is time to swap it out. Installation is simple: just unscrew the retaining cup and tip, remove the old electrode, and screw in the new one. With this 5-pack in your toolbox, you are ready for anything from auto body repair and exhaust work to heavy farm fabrication. Keep your cuts clean and your frustration low with genuine Hobart consumables.