1424=0527 - Victor 2.5-Inch Replacement Regulator Gauge 0-100 PSI

Keep Your Regulator Accurate and Safe

A broken or sticking gauge on your welding regulator isn't just an annoyance—it's a blind spot in your safety setup. The Victor Equipment 1424-0527 2-1/2" Pressure Gauge is the ideal solution for welders looking to replace a damaged low-pressure gauge. Rated for 0-100 PSI, this gauge is typically used to display your delivery pressure—the gas actually going to your torch. Knowing exactly how much pressure you are pushing is the key to dialing in that perfect neutral flame for oxy-fuel cutting or getting the right shielding gas coverage for MIG and TIG processes.

Why struggle to squint at a tiny, scratched-up dial? This unit features a generous 2-1/2 inch face, making it much easier to read at a glance while you are focused on your work. The clear, high-contrast markings show both PSI and KPA, so no matter what chart or procedure you are following, you have the numbers you need right there. The construction is tough enough to handle the rigors of a welding cart bouncing around the shop floor, but precise enough to give you the fine-tuning control you need for thin-gauge welding.

Don't let a $20 part compromise a $2000 job. If your current gauge has a bent needle, a cracked lens, or just doesn't return to zero, swap it out with this genuine Victor replacement. It is designed to fit perfectly on Victor regulators and other compatible equipment requiring a bottom-mount gauge in this pressure range. Maintaining your gear is part of the trade, and keeping your regulators in top shape ensures consistent gas flow, better welds, and a safer work environment for everyone in the shop.

This gauge comes packaged ready for installation. Simply remove your old gauge (remember to depressurize the system first!), apply appropriate thread sealant compatible with your gas service, and install the new Victor 1424-0527. You'll be back to burning metal with confidence in minutes.