53C005 - Walter Coolcut S-30 Water-Miscible Cutting Fluid 1 Gallon

The All-Purpose Cutting Fluid for Your Shop

Every fabrication shop needs a reliable cooling solution that can handle whatever job comes through the door, and Walter Coolcut S-30 is built exactly for that purpose. This 1-gallon jug of cutting lubricant concentrate is the perfect companion for your bandsaws, drill presses, and cold saws. Instead of buying expensive aerosol cans or using messy oils that smoke up the shop, you can mix this fluid with water at a 1:30 ratio to create a high-performance coolant that keeps your tools sharp and your cuts clean.

Fabricators often struggle with coolants that go bad, smell terrible, or cause rust on their equipment. Coolcut S-30 solves these problems with a special formula that fights off bacteria without using dangerous chemicals, keeping your sump tank smelling fresh. It also leaves a protective film on your equipment and parts, preventing flash rust after the cut is made. This is especially important when working with expensive materials or precision parts where surface finish matters.

Versatility is key in a welding and fab shop. Whether you are drilling through thick stainless steel plate, sawing aluminum extrusion, or turning mild steel, Coolcut S-30 provides the lubrication needed to prevent overheating and tool dulling. It contains Extreme Pressure (EP) additives that cushion the cutting edge, allowing for faster feed rates and smoother operation. Safe for use on all metals, including aluminum, it eliminates the need to stock multiple types of fluids. Just mix, fill your reservoir, and get back to work with confidence.