204611 - Miller 30ft Air-Cooled Induction Cable Protective Sleeve

Protect Your Gear with the Miller 204611 Cable Sleeve

You know that on a busy job site, your cables take a beating. Whether you are dragging them over concrete, pulling them around sharp steel corners, or working directly under a shower of sparks, your equipment is constantly at risk. The Miller 204611 Sleeve Cover is designed to take that abuse so your expensive induction heating cables don't have to. This 30-foot protective sleeve is the best insurance policy you can buy for your air-cooled induction setup, keeping your leads safe and your operation running smoothly.

This cover is built tough to handle the reality of welding work. It acts as a shield against the most common job site hazards: slag, molten metal, and abrasion. If a glob of hot slag lands on a bare cable, it can burn through in seconds, causing downtime and costing you money. With the Miller 204611 installed, that slag hits the durable cover instead, protecting the vital electrical components inside. It also acts as a heavy-duty abrasion guard. If you are constantly repositioning your heater around a large pipe or vessel, the friction against the ground can wear through standard cable jackets. This sleeve absorbs that friction, keeping your cable in pristine condition underneath.

It is important to note that this is a protective cover, not an insulation blanket. It is designed to let your air-cooled cables breathe while keeping the bad stuff out. Installation is simple, and the 30-foot length is perfectly sized for standard Miller air-cooled induction cables. Don't wait until you have a damaged cable to think about protection. By adding this sleeve to your rig now, you are ensuring that your equipment lasts longer and performs better, job after job.

Whether you are doing pre-heating on a pipeline or stress-relieving a structural weld, you need gear that keeps up with you. The Miller 204611 is a small addition that makes a big difference in the longevity of your tools. Keep your focus on the weld, not on where your cables are dragging, by suiting them up with this genuine Miller protective sleeve.