Miller ArcReach Induction Heating System CE

The Smart Way to Preheat

Stop wasting time dragging around propane tanks, rosebuds, and extra generators just to get your pipe up to temp. The Miller ArcReach Heater changes the game for field welders. This portable unit plugs directly into your standard welding leads. If you are running an ArcReach-equipped machine like the XMT 350 FieldPro, you already have the power you need. You simply disconnect your stinger or wire feeder, plug in the heater, and you are ready to wrap and heat. It is that simple.

This system uses induction heating, which is safer and more consistent than open flames. With a torch, you are constantly battling the wind, guessing the temperature, and risking hot spots that can ruin the metallurgy of the pipe. With the ArcReach Heater, you wrap the air-cooled cables or blankets around the joint, set your target temperature, and let the machine do the work. It brings the part up to temp quickly and holds it there exactly where you need it, allowing you to focus on laying down a perfect bead without worrying about the interpass temperature dropping.

Safety and Convenience
Because this is the CE model, it is built to the highest safety standards. The induction process means the heating cables themselves don't get red hot—only the metal part does. This significantly reduces the risk of accidental burns and eliminates the fire hazards associated with open flames on the job site. The unit is small enough to carry by hand, and since it uses the welding cables you already have strung out, you don't have to run special power cords or control cables. It’s the ultimate tool for welders who need to hit strict code requirements for preheat and bake-out without the headache of old-school heating methods.

Whether you are working on high-pressure steam lines or structural steel, the ArcReach Heater ensures you get the job done right, faster, and safer. It even records the temperature data, so when the inspector asks for proof of preheat, you have it ready to go.