0558004234 - ESAB MultiMaster 300 Foot Pedal Remote Control 30ft

Take Command of Your MultiMaster 300

Unlock the full potential of your ESAB MultiMaster 300 with the FC-5C Foot Control. For any serious fabricator, the difference between a good weld and a great weld often comes down to control. This foot pedal puts that control literally at your feet, allowing you to fine-tune your amperage on the fly. Whether you are feathering the heat at the edge of a thin sheet or punching it up for a thick tack, the FC-5C responds instantly to your movements. It is the ultimate tool for TIG welders who demand precision and fluidity in their arc, ensuring that every bead looks as good as it holds.

Freedom to Move

Stop dragging your welder around the shop! With a generous 30-foot cable, the FC-5C gives you the freedom to roam. We know that real-world welding doesn't always happen on a convenient bench. Sometimes you are under a chassis, up on a ladder, or on the other side of a large tank. This extended cable length means your machine stays safely tucked away while you go where the work is. It reduces trip hazards and saves you the back-breaking effort of moving your power source every few minutes. It’s about working smarter, not harder.

Built Tough for Real Shops

Your shop floor isn't a clean room; it's a place where things get dropped, stepped on, and used hard. The ESAB FC-5C is built to take it. The robust housing protects the sensitive internal electronics from the grit and grime of the job site. The heavy-duty strain relief on the cable prevents pull-outs and wiring failures, which are common in lesser pedals. When you plug this into your MultiMaster 300, you can feel the quality connection. It’s a piece of gear you can rely on Monday morning through Friday afternoon, year after year.

Smooth Operation, Better Welds

A jerky or sticky pedal can ruin a weld in a heartbeat. The FC-5C features a smooth, consistent travel that allows for seamless transitions. This is critical for starting the arc gently without blowing through the material and for tapering off the amperage at the end of a weld to fill the crater properly. The tactile feedback lets you know exactly where you are in the power range without having to look away from the puddle. Upgrade your setup with the FC-5C and experience the difference that genuine ESAB control makes in your daily fabrication work.