269815 - Hobart 5 ft. Reinforced Shielding Gas Hose for Barbed Regulators

Reliable Gas Flow for Your MIG Welder

Is your shielding gas hose cracked, leaking, or just too short? The Hobart 5 ft. Shielding Gas Hose (269815) is the genuine replacement part you need to get your welder running smoothly again. Leaking gas lines not only waste expensive shielding gas but can also lead to poor weld quality and porosity. This durable, reinforced hose is built to withstand the rigors of the shop environment while delivering a steady flow of gas to your torch.

Easy Installation for Barbed Regulators
One of the most common frustrations with replacement parts is finding the right fit. This hose is designed specifically for welders that use a regulator with a "barbed" outlet—a small metal nipple that the hose slides onto. It comes with a high-quality brass fitting already attached for the back of your machine, and a bare end with a hose clamp for your regulator. Simply screw in the machine side, slide the other end onto your regulator's barb, tighten the clamp, and you are ready to weld.

Genuine Hobart Quality
Don't risk your weld quality with generic tubing that might kink or burst. This is a genuine Hobart component, ensuring it meets the pressure and durability standards required for MIG and TIG welding applications. Whether you are restoring an older Hobart Handler or setting up a new rig with a specific regulator requirement, this 5-foot hose offers the perfect balance of length and durability.