Miller 010494 Nylon Snap-In Bushing 1.375 ID

Keep Your Miller Machine Running Smoothly

When you are out in the shop or on a job site, the last thing you need is a machine breakdown caused by something as simple as a frayed wire. The Miller 010494 Snap-In Nylon Bushing is a small but mighty part that plays a huge role in keeping your welder operational. It sits in the metal casing of your machine and acts as a smooth guard for the heavy-duty cables that run in and out of the power source. Without it, the constant vibration of the machine could cause the metal case to saw through your cable insulation, leading to shorts, sparks, and downtime.

This is a genuine Miller replacement part, meaning it is built to the exact specs of your machine. No guessing games with hardware store grommets that fall out after a week. This bushing snaps right into a 1.750-inch hole and stays there. The 1.375-inch opening is plenty big for your main power leads or thick wire bundles. Because it is made of tough nylon, it stands up to the heat and grit of the welding environment much better than cheap rubber alternatives that dry rot and crack over time.

Installation is a breeze—literally a snap. If you are doing a rebuild, replacing a damaged cord, or just noticed your old bushing is missing or broken, popping this new one in takes seconds. It’s cheap insurance for your expensive equipment. Don't let a rubbed-through wire fry your board or shock you while you're working. Keep your internal wiring safe and secure so you can focus on laying down perfect beads.

Whether you are fixing up an old Dialarc, a Bobcat, or a modern inverter machine that calls for this part number, sticking with OEM Miller parts ensures you maintain the resale value and reliability of your rig. Check your manual, grab the right part, and get back to welding with confidence knowing your gear is protected.