Miller 155195 White Cable Tie Anchor Base

Keep Your Miller Welder Organized with the 155195 Cable Tie Mount

If you are opening up your Miller welder for repairs or a deep clean, you might notice that the small plastic anchors holding your wires in place have become brittle or detached over time. The Miller 155195 Cable Tie Mount is the direct replacement you need to get everything tidied up again. It might seem like a small detail, but those wires inside your machine need to stay put. A loose wire can rub against a cooling fan, touch a hot transformer, or short out against the case, turning a simple fix into a major board failure.

This white cable tie mount is designed specifically for Miller equipment, meaning it will hold up to the heat and vibration that welders generate. It features a slot that accepts various sizes of zip ties—specifically M, I, or S sizes—so you can use it for thin trigger wires or thicker power cables. The white color makes it easy to spot inside the dark cabinet of your welder, helping you route cables logically and neatly.

Don't rely on generic hardware store sticky-backs that will peel off the moment your machine warms up. This OEM part is built to stick and stay. Whether you are replacing a control board, swapping out a fan, or just re-securing a harness that has come loose, having a few of these 155195 mounts on hand is a smart move for any welder repair project. It’s the professional way to finish a job, ensuring that when you close up the case, everything inside is secure and safe.

Installation is straightforward: simply position the mount where the original was located (or where cable routing is needed), secure it, and thread your cable tie through. It’s a low-cost insurance policy for the expensive internal components of your welding machine.