Miller 10/4 Power Input Cord 12.5ft Replacement

Keep Your Machine Running Safely

A welder is only as good as its power source, and that power source relies entirely on a solid connection to the wall. The Miller 284917 Power Cable is the factory-correct replacement cord for getting your Miller machine back up and running safely. Whether your old cord has been nicked by a piece of steel, crushed by a forklift, or simply worn out from years of service, swapping it out with this genuine Miller part is the best way to ensure consistent arc performance and shop safety.

Built for the Shop Environment

This isn't just a standard extension cord; it is a heavy-duty 10-gauge, 4-conductor power input cable designed specifically for the demands of welding equipment. The 12-foot, 6-inch length gives you enough slack to position your welder where you need it without creating a tripping hazard with excessive cabling. The internal wires are clearly colored Black, Red, White, and Gray, which takes the guesswork out of wiring it into your machine's terminal block. This means less time reading schematics and more time welding.

Safety First

Operating a welder with a damaged power cord is a serious risk. Exposed copper or compromised insulation can lead to dangerous shocks or short circuits that could fry your machine's internal boards. This Miller 284917 cable features a tough outer jacket meant to survive the sparks, grime, and rough handling typical of a fabrication shop. By choosing the OEM part, you know the wire gauge is exactly right for the amperage your machine pulls, preventing overheating at the plug or inside the cord. Check your machine's manual or serial number to confirm this 10/4 cable is the right match, and get back to welding with confidence.