Miller 240443 90-Degree Push-In Fitting 3/8 Tube x 1/8 NPT

Fix Your Welder with the Miller 240443 Fitting

When you are in the middle of a fabrication project, the last thing you need is a hissing gas leak or a dripping water line inside your welder. The Miller 240443 Fitting is the genuine replacement part you need to get your machine back up and running smoothly. This 90-degree elbow is commonly found inside Miller power sources, routing shielding gas or coolant through the cabinet. Its right-angle design is essential for making tight turns inside the machine without kinking the hose, ensuring consistent flow to your torch.

This fitting features a "push-in" style connection for 3/8-inch OD tubing, making installation incredibly fast and frustration-free. You simply push the tube into the collar until it locks—no hose clamps, no crimping, and no special tools required. On the other end, a 1/8-inch NPT male thread screws securely into your machine's valves or manifolds. Because it is an official Miller part, you don't have to worry about fitment issues or low-quality materials that might crack under pressure or vibration.

Don't risk your weld quality with generic hardware store fittings that might not stand up to the industrial environment. A leaking fitting can waste expensive shielding gas and cause weld defects like porosity, or worse, spray coolant on your main board. Swap out that damaged connector with the Miller 240443 and ensure your equipment is sealed, safe, and ready to weld. Whether you are performing routine maintenance or an emergency repair, this OEM fitting provides the reliability professional welders demand.