0194269002 - ESAB Control Cable Strain Relief Grommet

Fix Your Feeder and Protect Your Wiring

If you are restoring an older ESAB wire feeder or fixing up a trusty welding machine, don't overlook the small details that keep it running reliably. The ESAB Control Cable Grommet (0194269002) is the specific rubber bushing that sits where your control cable enters the machine case. Over time, these rubber parts can dry rot, crack, or simply go missing after years of service. A missing grommet might seem like a small issue, but it leaves your control cable rubbing directly against the bare metal edge of the machine's casing every time you move the feeder.

Once that metal cuts through the cable insulation, you are looking at intermittent connection issues, erratic wire feeding, or blown fuses that are a headache to diagnose. Installing a fresh, pliable grommet is the cheapest insurance policy you can buy for your welder. It provides the necessary strain relief so that if the cable gets tugged, the stress is taken by the rubber grommet rather than ripping the wires out of the circuit board inside.

This is a genuine ESAB replacement part, meaning it is sized exactly for the hole diameter and cable thickness of specific ESAB units. No need to mess around with electrical tape or generic hardware store grommets that pop out the moment you pull on the cable. Snap this in, feed your cable through, and get back to welding with the confidence that your equipment is sealed up and protected from the shop environment.