098615 - Miller 098615 Replacement Hose Assembly .187 ID x 20 Inch with Clamps

Get Your Machine Back Running with the Miller 098615 Hose

There is nothing more frustrating than a small leak shutting down a big job. If you are seeing a puddle under your Miller welder or hearing the hiss of a gas leak inside the cabinet, it might be time to replace an internal hose. The Miller 098615 is the exact replacement part you need to fix the issue and get back to burning wire. Don't waste time trying to cut generic bulk hose to size or struggling to find a hose clamp that actually fits a 3/16-inch line without stripping.

This kit comes ready to install right out of the bag. It is pre-cut to exactly 20 inches, so you aren't fighting with excess slack or coming up short. The inner diameter is a standard .187 (3/16 inch), and the outer diameter is .410, meaning it fits the barbs and grommets in your machine perfectly. Because it is a genuine Miller part, you know the rubber compound is designed to handle the heat and environment inside a welder, unlike cheap automotive hose that might dry rot or crack in a few months.

Best of all, this assembly includes the clamps you need. We've all been there—you pull the old hose off and the original clamp snaps or is too deformed to reuse. With the 098615, you have fresh hardware to ensure a tight, leak-free seal. Whether you are fixing a coolant line or a shielding gas tube, using the right part makes the repair faster and easier. Verify your serial number to make sure this is the right hose for your model, swap it out, and get back to work with confidence.

Why choose this replacement?

• Perfect Fit: No guessing on length or diameter.
• Ready to Go: Clamps included so you don't have to run to the hardware store.
• Miller Tough: Built to last inside your industrial equipment.