Miller Wire Feeder Pressure Arm Housing Assembly

Get Your Feeder Back on Track

There is nothing more frustrating than a wire feeder that slips, stutters, or just won't feed right. Often, the culprit is a worn-out or broken pressure arm assembly. The Miller 256035 Housing/Arm Assembly is the genuine replacement part you need to fix that drive roll tension and get back to laying smooth beads. If your current housing is cracked or the arm isn't applying the right pressure, your wire is going to slip, and your welds are going to suffer.

Don't mess around with trying to rig up a fix or using generic parts that might not fit quite right. This is the real deal from Miller, made specifically for your machine. It drops right in, fits perfectly, and restores that crisp, consistent feeding you expect from a Miller welder. When your wire feeds smoothly, your arc stays stable, and you spend less time grinding out bad starts and more time welding.

This assembly is built tough to handle the daily grind of the shop. It holds the idle roll in place and lets you dial in the tension just right. Whether you are running solid wire or flux-cored, having a solid drive assembly is key. Swap out that busted part with a fresh 256035 and stop fighting your machine.

Check your manual or look up your serial number to make sure this is the right part for your rig, and get your welder running like new again. Keep your arc smooth and your downtime low with genuine Miller parts.