Miller FCC/CE Compliance Label for Wireless Foot Control

Keep Your Wireless Gear Up to Spec

Your Miller Wireless Foot Control gives you the freedom to weld without being tethered by cables, but like all shop tools, it takes a beating. Over time, the stickers and labels on your pedal can get scraped, burnt, or soaked in oil, making them unreadable. The Miller 285735 is the direct replacement label for the FCC and CE information on your wireless control. While a sticker might seem like a minor detail, these markings prove that your wireless tool is legitimate, tested, and safe to use in your shop environment without messing with other electronics.

Using genuine Miller parts means you aren't sticking a piece of tape on your expensive equipment. This label is the real deal—the same one that came on the pedal when it was new. It uses strong adhesive that bonds well to the plastic or metal casing of the foot control, so it won't curl up after a few days of being kicked around the floor. Restoring your equipment with the right decals helps keep your setup looking professional and well-maintained, which is always a plus if you ever plan to sell your gear or if you have safety inspectors walking through your shop.

Application is simple: just make sure to thoroughly clean the surface of the foot control where the old label was. Remove any old adhesive residue, grease, or dust with a mild solvent or alcohol wipe, let it dry, and then peel and stick the new 285735 label in place. It’s a quick fix that brings your wireless foot pedal back to factory appearance. Don't let your high-end wireless tools look beat up; a fresh label pack is an easy way to show you care about your tools.