Miller 8-Inch Fume Extraction Hood Swing Arm Replacement

Keep Your Air Clean with the Miller 241018 Swing Arm Assembly

As a welder, your health depends on keeping the smoke out of your helmet and out of your lungs. A fume extractor is only as good as its positioning; if the arm won't stay put or the hood is flopping around, it's not doing its job. The Miller 241018 Swing Arm Assembly is the fix you need for your 8-inch fume extraction hood. This is the genuine replacement part from Miller, designed to get your extraction arm working like new again so you can focus on the puddle, not on adjusting a broken vent.

We know that shop equipment takes a beating. You are constantly grabbing the hood, pulling it closer to the weld, and pushing it away when you're grinding or setting up. That constant movement wears out the joints and swing mechanisms. When that happens, the hood might start to drift away from the weld zone, letting fumes escape into the shop. Installing the 241018 assembly restores the tension and flexibility of the arm. It allows you to position the 8-inch hood exactly where it needs to be to capture the maximum amount of smoke, and it stays there until you move it.

Don't settle for rigging your safety gear with duct tape or wire. Using the correct Miller part ensures that the airflow isn't restricted and that the mechanical movement is smooth. This assembly is built tough to handle the heat and grit of a welding shop. Whether you are working with a mobile FILTAIR unit or a wall-mounted system, if it uses the 8-inch hood configuration, this swing arm assembly is likely the part you need to get back to breathing easy.

Why You Need This Part

• Stay Safe: Keeps the fume hood exactly where you need it to suck up the smoke.
• Easy Adjustment: Fixes stiff or loose arms so you can move the hood with one hand.
• Genuine Quality: It's a real Miller part, so you know it fits your machine.
• Professional Setup: Keeps your station looking and working like a pro shop.