0558008615 - ESAB 24V AC Solenoid Valve 16 Bar Replacement

Get Your Machine Back to Work

Is your ESAB welder or plasma cutter acting up? If you are experiencing issues with gas flow—whether it's not turning on when you pull the trigger, or leaking when the machine should be idle—the solenoid valve is often the culprit. The ESAB 0558008615 is the genuine replacement 2-way solenoid valve designed to get your equipment running smoothly again. Don't let a small part stop your production; swapping out a faulty valve is a standard repair that can restore your machine's performance instantly.

This valve operates on 24 Volts AC, which is the signal your machine sends to open the gas line when you are ready to weld or cut. It is built tough to handle up to 16 Bar of pressure, meaning it can easily manage the high-pressure air required for plasma cutting or the shielding gas for your MIG/TIG setup. Because it is an official ESAB part, you don't have to worry about it fitting correctly or having the right electrical connections. It drops right into place where the old one was, ensuring your gas lines seal tight and your flow is consistent.

Why use genuine ESAB parts?
Using generic valves can be risky. They might not open fast enough, leading to porosity at the start of your weld, or they might not close completely, wasting expensive argon or mix gas. This OEM valve is tested to work perfectly with your ESAB machine's timing, giving you the correct pre-flow and post-flow every time. It’s a small investment to protect the quality of your work and the efficiency of your consumables.

Whether you are fixing a plasma cutter that won't blow air or a welder that's leaving your puddle unprotected, this solenoid valve is the reliable fix. Keep your shop running and your welds clean by replacing worn-out gas controls with the part intended for the job.